How to Install a ChameleonMini Rev.G Driver on Windows 10
The ChameleonMini Rev.G comes with factory test software out of the box. You will need to upgrade to the latest firmware first by following this guide. After you have completed these steps please follow the instructions below.
Before beginning, be sure to download the driver here.
Step 1: Connect your ChameleonMini Rev.G and power it on.
Step 2: Open Device Manager and navigate to the Ports section.
Step 3: With your ChameleonMini Rev.G connected right click on the USB Serial Device (COM#). Click Update Driver.
Step 4: Click Browse my computer for driver software
Step 5: Click Let me pick from a list of device drivers on my computer
Step 6: Click Have Disk
Step 7: Navigate to the location of the ChameleonMini Rev.G Driver you downloaded earlier. It should be a file in the driver folder called Drivers. Once selected click open.
Step 8: Click OK and then Next. Your Proxmark3 driver should now be installing.
Click 9: You should receive a dialog box window saying the driver was sucessfully updated. Click Close.
Step 10: You should now see under ports "ChameleonMini Virtual Serial Port (COM#)".
Your driver is now installed correctly. You can continue the setup process by following the Getting Started Guide.
Also in Blog

Making a Physical Mifare 1K UID Clone

Making a physical HID Prox 2 Clone - Firmware V3.0.1
