ProxmarkPro - Power Modes - Getting Started
This is one section of the full ProxmarkPro Getting Started guide. You can find a PDF copy of the entire guide here.
The ProxmarkPro has two power modes: Battery and USB. These modes are controlled through the use of the power switch pictured below.
Placing the switch in the leftmost position will power the device from the built-in battery. Placing the switch in the rightmost position will power the device over USB when connected to a host and charge the battery simultaneously.
How to charge your ProxmarkPro
- Connect your ProxmarkPro via USB and the LED should come on. Put switch in USB position.
- When the LED goes off the Pro is fully charged.
- You can also check the status of your charge by going to the device menu and then click battery. Please note this is only an estimate.
** Warning: Antenna Port is not power, please make sure you plug in your ProxmarkPro via the Micro USB Port. **