Reading Tags with the ChameleonMini Rev.G

January 06, 2017

These step by step instructions cover how to read an HF Tag (13.56 MHz) with the ChameleonMini Rev.G. 

What you will need:

Take a look at the Getting Started Guide if you need help with the setup process.

1. Connect up your ChameleonMini and start the client.

CMini Rev.G Hookup

2. Inside your client enter the following command to configure the ChameleonMini as a reader. 

Config=ISO14443A_READER

Output:

100:OK=ISO14443A_READER

3. Place tag near the ChameleonMini. Run the read command.

GETUID

Outputs:

Mifare Ultalight

101:OK WITH TEXT
041891EA453181

Mifare 1K

101:OK WITH TEXT
5C9F9F0D

Mifare 4K

101:OK WITH TEXT
FE333A53

Mifare Desfire EV1

101:OK WITH TEXT
04113B624D3C80





Also in Blog

Getting Started with Version 3.0.1 of the Proxmark3
Getting Started with Version 3.0.1 of the Proxmark3

November 06, 2017

This guide covers how to get started with the Proxmark3 firmware V3.0.1 on Windows, Linux and macOS.

View full article →

Getting Started with ChameleonMini Rev.G
Getting Started with ChameleonMini Rev.G

October 23, 2017

Follow this guide to get started with your new ChameleonMini Rev.G using macOS, Windows and Linux.

View full article →

How to Install a Proxmark3 Driver on Windows 10
How to Install a Proxmark3 Driver on Windows 10

October 18, 2017

Follow the instructions below to install the Proxmark3 CDC drivers on a computer running Windows 10.

View full article →